Product introduction
This product is an automatic tin breaking and rolling device. After drilling the solder wire, the solder wire will be cut and rolled up automatically for use. Simple operation, breaking tin roll tin fast.
The rolled tin wire is combined with the lead-free welding table to form the automatic tin breaking manual welding table, which can effectively solve the problem that the operator holds the soldering iron in one hand while waiting for the breaking
Tin work awkward situation. The broken tin line can be stored and used without affecting the production cycle. Broken tin wire with welding table stable performance, can
Effectively solve the manual welding of non-standard parts and small parts. Minimize the problem of tin explosion.
Automatic control: set the time and speed of breaking tin. Set the left and right limits of the translation platform. The solder wire is fed from the tin breaker through the wire device,
Counterweight adjusting device, tin receiving device. Automatically complete the entire tin breaking and rolling process. No manual intervention is required during work. This machine automatically all welding
The hole depth of the tin wire is consistent. Ensure product welding quality.
The machine is specially designed for high-tech products such as automotive electronic parts, LED lighting, electro-acoustic devices, ceramic components, etc., which require strict environmental cleaning requirements.
Product advantage
The solder wire of automatic soldering, which contains flux aid, melts when the flux in the tin wire meets the high temperature of the iron head in the soldering process
Boiling in the metal, the high pressure caused by this boiling reaction often causes the phenomenon commonly known as "tin explosion", and the boiling flux with tin explodes and drops instantly
Warm, and finally form small tin balls on the substrate. The spatter of tin ball particles after the tin explosion is easy to cause damage to the eyes and skin of the operator. Simultaneous tin ball
If not cleaned, it is easy to cause short circuit on the substrate, which seriously affects the welding quality. The automatic solder if you want to load the visual inspection system, the cost is not
Only too high and also lengthens the entire process time.
In order to avoid tin explosion in the soldering process, our company has developed an automatic tin breaking and rolling machine, which uses precision machined knife gear to press fine on the side of the tin wire
The holes allow the flux to seep out, allowing most of the flux to boil around the metal. The "tin burst" caused by flux boiling in the soldering process is greatly avoided. avoid
The operator's eyes and skin will not be harmed by the small tin ball particles produced by the "tin burst", nor will it be produced by flux or tin burst
The tin ball affects other sensitive components on the PCB board, effectively ensuring the cleaning of the welding parts.
